15
5. Then set it on the Motor Housing.
6. Plug in and press the switch button.
While operating, hold the Lid-J down.
7. Use Fruit Pusher
8. To Transfer the Juice
When adding extra ingredients, turn off the
switch. Remove the Plastic Jar from the Motor
Housing and repeat step 3-5
Never open or close the Lid-J when the Plastic Jar is placed on the Motor housing as the Blade is
still moving for a while after switching off
If any fruit ingredients get stuck inside the Filter unit above the
Blade without getting crushed, Use Fruit Pusher by following the
directions below :
1. Line up the triangles.
2. Turn the Jar until
it stops
the Lid Cover with the Mixer in running condition.
Insert the Fruit Pusher into the Filter unit in the direction as
illustrated in the image
Stir down the un-crushed fruits by Fruit Pusher towards the Blade.
Pusher from the Filter unit.
After extracting Juice, press the “OFF” button and remove the
Plastic Jar from the Motor Housing. Open the Juice Cap and transfer
the Juice to the containers.
3-5
1
2
3
4
5
“OFF”
3-5
“OFF”
1
2
3
4
5
Step-1:
Step-2:
Step-3:
Step-4:
Step-5:
To Next Page
Loading...
