How to Use Plastic Jar with Filter Unit
1. Filter Gasket fixing.
2. Put the Filter in the Plastic Jar .
3. Put ingredients.
4. Put the Lid-J on the Plastic Jar first.
Fix the Filter Gasket at the bottom of the Filter.
Please ensure, the rib of the lter is placed
properly on the Plastic Jar Flow Breaker lines.
These Grooves are located at the top of Plastic Jar Flow
Breaker Lines.
Plastic Jar Flow Breaker Lines
These Grooves are located at the bottom of Plastic Jar
Flow Breaker Lines.
Cut the ingredients into small enough pieces to t in to the feeder hole with proper water capacity.
Make sure the buttons are not pressed down on the Motor Housing.
Set the hook of Lid-J onto the Plastic Jar. Make sure the Lid cover is
closed over the Lid-J.
Turn the Lid Cover until it stop.
14