24
10.9. Upper Support Bracket
1. Remove two screws fixing the body group at the front as it
is shown in the picture.
2. Remove two screws fixing the body group at the upper as
it is shown in the picture.
3. Remove detergent drawer group two clips fixing the upper
support bracket as it is shown in the picture.
10.10. Detergent Drawer Housing
1. Remove the tub seal clamp by using the pliers, which is
attached to the detergent drawer housing.
2. Remove the four connectors that is connected to the feed
valve as it is shown in the picture.
3. Turn the feed valve counter clockwise slightly to remove.
To Next Page
Loading...
