Panasonic NA-128VA2

33
Installation
Instructions
Choosing the right location Moving and installing
Moving and installing
Removing the anchor bolts
Four anchor bolts keep the interior of the washing machine in place while it’s being moved. They
need to be removed before installation, using the spanner supplied and following the instructions
below.
Don’trunthewashingmachinewithoutremovingthebolts,asthiscan
causeexcessivevibration.
B
A
B
● To remove the anchor bolts:

Use the ‘B’ end of the spanner to loosen the
four bolts.

Pull the bolts out horizontally.

Remove the screws which are alongside the
bolt holes.

Push the four cover caps (included with your
accessories) onto the respective bolt holes,
and secure them with the screws you removed
in step .
You’llneedtheanchorboltsagainifyoumovethewashingmachine,so
make sure you keep them safe. And if the washing machine passes to
someoneelse,makesureyougivethemtheanchorbolts.
NA-168VX2_Eng.indb 33 2010-1-26 13:05:59