Why no water flows into my Panasonic NA-128VG5WAU?
If no water is flowing into your Panasonic Washer, the water tap may be turned off. Other possible causes include a frozen water supply hose or a disruption in the water supply.
How to unlock buttons on Panasonic NA-128VG5WAU Washer?
If buttons on your Panasonic Washer don't work after starting a wash, you can only switch over by pressing Start/Pause during washing. To change the program, temperature, or settings after rinsing starts, switch off the appliance and then switch it back on. Also, check if the child lock is activated.
Why water flows into my Panasonic Washer but is not stored?
If water flows into your Panasonic Washer but isn't stored, avoid opening the door to pour water or hot water directly into the drum, as this can cause the water to drain immediately. Also, when you restart the appliance, water drainage may occur.
Why is water drained mid-way in my Panasonic Washer?
If water is being drained mid-cycle in your Panasonic Washer, this may be because the appliance has detected too much foam. The washer may repeatedly drain and supply water to remove the excess foam.
Why does the spin drying step start and stop repeatedly on my Panasonic NA-128VG5WAU Washer?
If the spin drying step in your Panasonic Washer starts and stops repeatedly, this is normal. The spin drying step may be repeated but it will be preformed quietly. The laundry may also be too light. If so, add one or two bath towels.
Why does water flow into my Panasonic NA-128VG5WAU Washer mid-way?
If water flows into your Panasonic Washer mid-cycle, it's likely because the water level has dropped, and the appliance is automatically replenishing it. When the amount of the laundry is large, water may be automatically replenished several times.
Why does the drum stop and rotate during spin drying in my Panasonic NA-128VG5WAU?
If the drum in your Panasonic Washer stops and rotates from time to time during spin drying, this is normal. The appliance has detected an unbalanced load and is trying to correct it.
Why is no water seen during washing in my Panasonic Washer?
The amount of water used in washing is less in a drum washing machine than in a pulsator washing machine.
Is it normal for foam and water to remain on the door seal of my Panasonic NA-128VG5WAU?
Although some foam and laundry washing water might remain on the door or the door seal of your Panasonic Washer depending upon the state of the laundry and the amount of detergent used, the performance of the rinsing step is unaffected.
Why is water being drained mid-way from my Panasonic NA-128VG5WAU Washer?
If your Panasonic Washer is draining water mid-cycle, it may be due to excessive foam. The appliance may repeatedly drain and supply water to remove the foam.
To Next Page
General