To Next PageTo Next PageHow to fix Panasonic NA-128VG5WAU Washer buttons not working?
If the buttons on your Panasonic Washer aren't working, remember that after starting a wash, you can only use the Start/Pause button to switch over during the washing cycle. To change the program, temperature, or settings after rinsing has started, you'll need to switch off the appliance and then switch it back on. Also, check if the child lock is activated.
Why does rinsing start before spin drying finishes in my Panasonic NA-128VG5WAU?
If the rinsing process begins before the spin drying process finishes in your Panasonic Washer, it means that the laundry has leaned to one side, and the corrective rinsing process will begin to automatically correct the phenomenon of leaning to one side.
Why does my Panasonic NA-128VG5WAU have an unusual odor?
Rubber parts may give off a smell when you start using the appliance, but the smell will go away over time.
Why is no water flowing into my Panasonic NA-128VG5WAU?
If no water flows into your Panasonic Washer, the water tap might be turned off. The water supply hose could be frozen, or the water supply may be disrupted.
Why does rinsing start before spin drying finishes on my Panasonic Washer?
If the rinsing process starts before the spin drying finishes on your Panasonic Washer, it's because the laundry leans to one side. The washer will automatically correct this by beginning a corrective rinsing process.
Why is there foam and water on the door of my Panasonic Washer?
If you notice foam and water on the door or door seal of your Panasonic Washer, it's normal. Some foam and laundry washing water might remain depending upon the state of the laundry and the amount of detergent used, but the rinsing performance is unaffected.
General