Panasonic NA-F125A1

12.2 H-Error indication
●Ifthereisanoperationerrororifthereisaproblemwiththewashingmachine,
- All the switchs cannot be operated.
- An error indication will be displayed.
- 17 -
Indication
Content Check Point Method to clear
H01
Water level sensor
error
●Checkatconditionoftheconnector
●Disconnectthepower
plug--->plug in
●ReplacethePressuresensorswitch
●ReplacePCBboard
H02
Motor triac error
●Inwaterdrainactioncheckbothsideof
●Disconnectthepower
plug--->plug in
capacitor that voltage not equal to “0” V.
●ReplacePCBboard
H04
Load relay short
error
●AfterturnontheMotorfor2seconds,
capacitor voltage is not “0”
●ChangeCapacitor
H05
The memory circuit
of IC error
●ReplacePCBboard
●Disconnectthepower
plug--->plug in
H12
Safety switch
connection error
●ReplaceSafetyswitch
●Disconnectthepower
plug--->plug in
H17
Thermistor error
(for X series)
●ReplacePCBboard
●Disconnectthepower
plug--->plug in
H21
Overowerror
●CheckFeedvalveandPCB
●Disconnectthepower
plug--->plug in
●ReplaceFeedvalve