16
Error Display
● The buzzer sounds and “U”/“H” and a number are alternately displayed.
● Cancel Child Lock (P. 11) if it is set.
Error display Points to be checked
Water cannot drain.
Check the drain water hose for the following abnormalities:
● Is it crushed?
● Is it clogged with lint?
● Is the hose tip under water?
● Is it partially raised higher than 10
cm above the oor? (P. 14)
● Is the total length longer than 3
m (including the extension hose)? (P. 14)
When the above problems are solved, you can resume operation by opening and
closing the lid.
The lid is open.
● Did you try to run the washing machine with the lid open?
→Close the lid.
Spin or Air Dry is not possible.
● Are clothes concentrated on one side of the tub?
→Distribute the clothes evenly and close the lid.
● Is the washing machine installed on an unstable
or inclined surface?
→ You can resume operation by opening and
closing the lid.
Water cannot be supplied.
● Is the water faucet turned on?
→When using Temp Setting, Collar/Cuff, Oil and Curry programs, turn on both hot
and cold water faucets.
● Water outage?
● Is the water supply lter clogged with dirt? (P. 13)
→You can resume operation by opening and closing the lid.
Water has been forcibly drained.
● Water has been forcibly drained because the lid was open for 10
seconds or more
with Child Lock (P. 11) set.
→ Unplug the power cord and plug it in again after 5
seconds.
Inspection is required.
● Turn off the water faucet just to be safe. Then, report the error displayed (2-digit
number after “H”) to a service person. Unplug the power cord.
Hot /
Warm
lamp
(P. 4)
Flashing
Normal operation
(The lamp ashes only during hot water supply.)
Flashing
quickly
The hot water faucet is not turned on / not connected.
● The washing machine operates using cold water.
(May cause less washing performance)
● The lamp continues ashing during operation or for 8 hours after operation until
the lid is opened.
To Next Page
Loading...
