7.6 The MOTOR replacement
1. Lay down the washing machine on it right side.
2. Remove both lead wire connectors from the MOTOR and the ROTARY SENSOR.
3. Loosen four bolts (M13) mounting the motor by using HW-18, and remove V-belt.
4. Remove four bolt mounting the MOTOR, and remove the motor.
Note: After replace the motor, adjust tension of the V-belt properly.
And then, set micro-processor to initial mode of V-belt tension by operating
Test-No water / Check procedure-E.
7.7 MOTORIZED DRAIN VALVE replacement
1. Lay down the washing machine on it left side.
2. Remove connector from the MOTORIZED
3. Remove three screws mounting the
4. Remove slider portion of the MOTORIZED
DRAIN VALVE from the COCK ROD A.
1. Lay down the washing machine on it left side.
2. Loosen clamp and remove two hoses from the PUMP CASING.
3. Remove three screws mounting the PUMP BRACKET.
Checking tension
of the V-belt
To Next Page
Loading...
