7
HOW TO INSTALL
Installing this Washer should be settled in a
well-ventilated, safe place and where can
connect the drain hose and the power supply.
It is recommended to place the washer on a level
foor and avoid a place where the washer can be
exposed to direct sunlight.
Insert the power plug firmly into
the power outlet.
Pull out the drain hose from the
washer. When using the washer
for the first time, you may find
water remaining in the drain
hose. It was used for the factory
performance test. It does not
imply any malfunction.
The inlet hose
connector, which
supply the water
into the
washing tub and
spin tub can be adjusted
The new hose-sets supplied with
the appliance are to be used and
the old hose-sets should not be
reused.
If the installation, test run and inspection of the washing machine are not carried out following this installation
Panasonic
OI NA-W100G1 En-AR-PE.indd 7 3/5/2558 BE 3:18 PM