Panasonic NV-DS11EN - Copying with Editing Controller; Connecting Editing Controller; Editing with Time Code

Copying with the Help of an Editing
Controller
tf you connect the Movie Camera to an Editing Controller
equipped with 5-pin
Edit Socket, this Movie Camera's
playback functions can be controlled from the Editing
Controller.
After making the connections shown above, perform
the necessary operations.
aWhen you periorm editing with the NV-HS1000 VCR
(optional) connected to this Movie Carnera. first activate
the Still Playback Mode on the Movie
Camera and then
start the actuat editing operation.
When Connecting the Editing Controller
VW-ECSOOE
O (optional)
*A VCR equipped with 5-pin Edit Socket is necessary.
OWhen you connect the VW-EC5OOE to the Movie
Camera, an adjustment on the VW-ECSOOE is
necessary. For the operation of the Editing Controller,
refer to its operating instructions.
When Editing with Time Code
Set [DISPLAY] on the [DISPLAY
SETUP] Sub-Menu of
the [VCR
FUNCTIONS] Main-Menu to [TIMECODE] to
make the Time Code
appear.
OWhen the Time Code is displayed, the Time Code
Signal is output from the
Edit Socket.
OWhen the Counter Indication is displayed, the Linear
Tape Counter Signal is output.
To
Edit Socket
Edit Socket
O Connect the AC Adaptor.
@ VCR (not cuppiied)
O TO Edit Socket
@TV (not supplied)