i
RSfZ%B
[CHARGE]
~.~.
. .
-,
L
I
-
~-
=r
~
-
-
.
.L.
-~
~
.
~
-
~-
~
.-
.~ .-
.
~
~~
.~
~
~.
~
~
.
~
.
~
..
~
Supplying Power with the Battery
Before use. fully charge the Battery.
1
Place the Battery on the AC Adaptor as
shown above and slide it horizontally until
it stops.
If the DC Input Lead is connected to the AC Adaptor.
disconnect it as charging is not possible
othewise.
2
Securely connect the AC Mains Lead to the
AC Adaptor and an AC Mains
Socket.
*The [POWER] Lamp
O
lights and then the
[CHARGE] Lamp
@
flashes for a few seconds
before it remains lit and charging starts.
*If the [CHARGE] Lamp does not flash even though
the
Banery is atiached, remove the Battery and
then
re-attach it.
*When the [CHARGE] Lamp goes out, charging
is
finished.
3
Rernove the Battery by sliding it in the
opposite direction of Step
1
above.
*Also disconnect the AC Mains Lead.
4
Slide the Finder backward to its fully
extended position and then tilt it upward.
5
lnsert the Battery into the Battery Holder
on the Movie Carnera and slide it
downward until
it
locks with a click.
Removing the Battery from the Movie Camera
While pressing the [BATTERY EJECT] Button, slide the
Battery upward to remove it.
*Be careful not to drop the Battery
by
accident.
Before removing the Battery, set the
[OFFION]
Switch
to
[OFF].
H
Charging Lamp [CHARGE]
Flashing: During checking of the Battery condiiion
Lit. During charging
Off: The
Battery is fuliy charged.
*If you charge the Battery when 11 is not yet discharged.
ine [CHARGE] Lamp may
flash briefly and then go out.
Tns
ndicates thai the Battery is fuly charged.
Therzfore thrs is
not
an !ndicatic?
of
3
r;alfunc!!sn.
48-
To Next Page
Loading...
