Panasonic NV-RX1A - Page 17

A built-in rechargeable lithium battery inside the
Movie Camera maintains the operation of the
built-in clock when the Movie Camera is not in
operation. Whenever the Movie Camera is in
operation, it automatically recharges this battery.
However, if you don’t use the Movie Camera for a
very long time, the lithium battery can become
exhausted.
In this case, the “&” Indication in the Viewfinder
flashes and the date returns to the initial Indication
“1.1.1990",
if the “&” Indication in the Viewfinder flashes for
approx. 10 seconds when you turn the Movie
Camera on, the date and time settings have been
reset because the lithium battery has been
exhausted. Recharge it as follows:
3 “4TRACKING >
DATE
TIME
SH SET
Press to set to “1996”.
/ “ATRACKING>
DATE
TIME
SHIFT SET
Press to set to “15”.
17
<4TRACKING>
DATE
TIME
SHIFT
SET
Press to set to “30”.
No indication
12:30
15.10.1996
Date and Time
“4TRACKING >
se)
prs
HIFT
Press to make the
“Month” portion flash.
8 “TRACKING >
DATE
TIME
AFT SET
Press to make the
“Hour” portion flash.
12
“(TRACKING
DATE,
TIME
LET SET
Date only
15.10.1996
Press to start the clock.
1 Connect the Movie Camera (with power off
condition) to the AC Adaptor and wait for
approx. 8 hours.
2 Switch on the Movie Camera.
3 Set the date and time as explained below.
After charging the lithium battery in this way, it
can maintain the operation of the clock for
approx. three months.
Information for your safety
WARNING
THE LITHIUM BATTERY IN THIS UNIT
MUST ONLY BE REPLACED BY
QUALIFIED PERSONNEL. IF THIS IS
NECESSARY, CONTACT THE
PANASONIC CUSTOMER CARE CENTRE
ON 132600 FOR YOUR NEAREST
AUTHORISED SERVICE CENTRE.
Remarks, etc.
@
Changing
the
Figures
of
the
Date/Time
Indication
You can change the Date/Time Indication in the order
shown below by pressing the [SET] Button repeatedly.
For example:
Year; 1990-1991 ..... 2089->1990->
Month; 5 Dee re Sa er a > 121...
Day; 192 ocean 33115
Hour; Otro en 23-0...
Minute; 00-01 2... —59-—-00->...
lf you want to change the figures more quickly, keep
the [SET] Button pressed.
if you make a mistake during setting, start again from
the beginning.
Movie Camera Set-Up complete, now ready to use.
Basic Operations |
17