Panasonic NV-RX1A - Controls and Functions

Using the Remote Controller (NV-RX2A only)
4
1
2
(2)
O
3
@ Operating Range for the
Remote Controller
@ Controls and Functions
1 [W-T] Zoom Buttons (p. 19)
2 [REW] Button (p. 26, 42)
Use this Button for:
Recording Review
Review
e@REW (Rewind)
e@Camera Search
3 [PAUSE] Button (p. 27)
Recording Start/Stop Button (p. 19) -
5 [FF] Button (p. 26, 43)
Use this Button for:
eCue
eFF (Fast-Forwarding)
Camera Search
6 [PLAY] Button (p. 27)
7 [STOP] Button (p. 27)
aS
@ How to Insert the Button-Type Battery
1 Pull out the Battery Holder while pushing
the stopper.
2 Turn the Battery Holder upside down and
insert the Battery with the (++) mark facing
downward until it locks with a click.
3 Insert the Battery Holder into the Remote
Controller.
@ Replacing the Button-Type Battery
The life of the battery is about one year.
Replace the exhausted battery with a new CR2025
Battery.
Information for your safety
WARNING :
“THE LITHIUM BATTERY” IS A CRITICAL
COMPONENT (TYPE NUMBER CR2025
MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO
EXCESSIVE HEAT OR DISCHARGE. IT
MUST THEREFORE ONLY BE FITTED IN
EQUIPMENT DESIGNED SPECIFICALLY
FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF
THE SAME TYPE AND MANUFACTURER,
THEY MUST BE FITTED IN THE SAME
MANNER AND LOCATION AS THE
ORIGINAL BATTERY, WITH THE
CORRECT POLARITY CONNECTIONS
OBSERVED.
DO NOT ATTEMPT TO RE-CHARGE THE
OLD BATTERY OR RE-USE IT FOR ANY
OTHER PURPOSE IT SHOULD BE
DISPOSED OF IN WASTE PRODUCTS
DESTINED FOR BURIAL RATHER THAN
INCINERATION”.