Panasonic NV-RX1A - Charging the Battery Pack; Attaching the Charged Battery Pack

12
)
Do not connect the Movie
| Camera during charging.
RG
re
f
“CHARGE” Lamp
On: During charging.
Off: Charging is finished.
(For maximum charge, continue charging for
2 hours after the “CHARGE” Lamp has gone off.)
Title
Charging the Battery Pack
©Be sure to insert the mains plug completely into the
correct socket.
®Do not connect the DC Input Cable to the AC Adaptor
otherwise the Battery Pack cannot be charged.
@Ni-MH (Nickel-Metal-Hydride) Battery Packs
(VW-VBH10E and VW-VBH20E) may not perform
very well in cold conditions (e.g. the snow).
Never remove the Battery Pack during recording or
playback, because the tape would remain in contact
with the video heads and this could cause damage to
the heads and tape.
Attaching the Charged Battery
Pack
If an exhausted Battery Pack is
attached, the “{Xh” Indication in the
Viewfinder flashes, when you turn the
Movie Camera on.
Charge Confirmation Marker
Use this marker to distinguish between charged and
discharged Battery Packs. For example, slide the
Button so that the dot is visible after charging is
completed.
BATTERY EJECT @)
Procedure
Attach the Battery Pack.
Attach the Battery Pack
with its Charge
Confirmation Marker
facing upward.