[_1 SeTr,.o412000:AUTOPUS.C.Ue_CO_OCLOCKTUE:C.OST12:00PMset0_:o"
Ifthe displayed time is correct, press CH • to exit.
• This concludes one time VCR setup.
• See important note at the bottom of this page.
If the displayed time and DST. are not correct...
ifyou happen to live close to two time zones, the VCR
• may have recognized the PBS channel (setting channel)
in the wrong time zone. Please do the following to
correct the situation.
a Make a note of the SETTING:CH number shown on-
screen and press CH • to exit.
• b Delete the setting channel from the VCR channel
memory. (See To Add or Delete a Channel"
section on page 14.)
c Press ACTION to display the menu.
d Press •V to select =SET CLOCK," and then
press • to display the =SET CLOCK* screen.
• Press •V to select "AUTO CLOCK SET," and then
press • to display the =CLOCK AUTO SET" screen.
f Press CH • to start Clock Auto Set.
• If youuse a cable box and have multiple PBS stalJons,
tune the cable box to a different PBS station and try auto
clock set using the menu.
SELECT/SET
(&v<,)
keys
CHANNELUP
I AUTO CLOCK SET I
- IS INCOMPLETE I
PUSH ACTION TO SET CLOCKJ
If the Screen CASE 2 appears =AUTO CLOCK
SET IS INCOMPLETE" P12, auto clock set is not
available in your area. Please set the clock
manually as described below.
a PressACTION to displaythe
SET CLOCKscreen.
b Press•Y and• • to -- -
selectandsetthe month,
date,year,time, and
DST.(DaylightSavingTime).
DST:ON
I
SELECT:& • KEY
SET :1_ KEY
END :ACTION KEY
To Make Corrections,
repeatedly press • • to move the cursor
to the incorrect entry and make the correction.
C Press'ACTION twice to start
the clock and exit this mode.
SET :4 I_ I_EY
START :ACTION KEY
IMPORTANT NOTE FOR AUTO
CLOCK SET WHEN USING
CABLE BOX OR DSS RECEIVER
° Auto clock set will be performed when
the VCR is tumed off the first time each
day. If you use a cable box and you
want auto clock se.t to be performed,
the cable box must be left on and tuned
to the PBS channel before the VCR
power is tumed off.
• Ifyou use a DSS receiver, it must be
tumed off for auto clock set.
• Ifyou use Audio/Video Jack connection
between the VCR and Cable Box or
DSS receiver, you must also connect
the RF coaxial cable in order to use th_
auto clock set and channel auto set
features.
13
To Next Page
Loading...
Need help?
General