Panasonic Omnivision PV-M1346

Your Combination VCR can be set up to
do a recording while you are away or
otherwise occupied. Up to 8 programs can
be placed in memory. You can choose to
record one time, daily, or weekly.
IS ek list before you begin.
L] All connections are made. (See page 5.)
Your Combination VCR is plugged in.
[ ] The clock is set.
[ ] The tape is long enough.
[ ] The record tab is in place.
PROGRAM TIMER STOP/EJECT
indicator
STOP
E mE . Push PROG to display START STOP CH
lj O the program screen.
PROG * If a program is already in
SELECT START DATE
memory, use the Wheel to Ev ROTATING WHEEL
select an unused program
number. : PUSH WHEEL
umbe TO END PUSH PROG KEY
BN
sm.
Hotate
and
push
the
РВ
(a
==
WHEEL
to
select
and
ко
—7-—э8-9-—31-
set
the
DATE.
|
i
hon Wheel Selection Order |
WEEKLY(SUN = DALY — G
Daily and Weekly Timer Recording
If you want the program to be recorded daily
(Mon thru Fri) , enter DAILY in place of the
DATE in step 2. If you want the recording to
be on a weekly basis, enter WEEKLY MON,
YO EN) EAST
TUE etc BY ROTATING WHEEL
r .
¿PUSH WHEEL
TO EN> PUSH PROG KEY
Rotate and push Remaining Items to be set:
the WHEEL to DUM
| select and set * CH(annel) number,
it remaining items or LINE for outside
at right. source recording.
* Speed (SP, LP, SLP).
To Make Corrections
Repeatedly push the Wheel to move forward, or the CLEAR button to
move back to the desired item.
Push PROG to end P ОТ STRAT STOP CH SPD
the program. o A
PRO js A oce ras En
Ө * If you want to enter more ае оа оза паса oe
== programs, select a blank EET 10 ROTATE WES
program number with Wheel CANCEL :PUSH CLEAR KEY
and repeat steps 2 and 3. ЕМО :PUSH PROG KEY
Push PROG to exit
this mode.
PROG * The PROGRAM TIMER indicator
lights on the front panel.
Cn
* If you're using a cable box, make sure that it is tuned
to the desired channel and the power is left on for
timer recording.
Two minutes before the Timer Recording starts, "TIMER REC WILL START
SOON” will appear on-screen.
-
+ Kf “PLEASE PREPARE FOR TIMER REC" appears and/or the PROGRAM TIMER indicator flashes, check that a
cassette with record tab is loaded and the Combination VCR is in Stop mode.
• If the start times of two programs overtap, the tower numbered program will have priority.
* If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 15),
the timer recording will not be performed.
» If there is a power interruption of more than one minute, the recording may not be performed or continue.
«
If
PROGRAM
IS
INCOMPLETE”
appears
on-screen
in
step
4,
check
ail
entries
and
make
necessary
corrections
.
16