Panasonic Omnivision PV-M1346

Channel & Function Display
Whenever the channel is
changed, the Channel
number will appear for a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.)
the Combination VCR
mode will be displayed.
* When a recording is started, both REC and
the channel will appear together.
Menu Screen
MAIN MENU
1 Push the MENU button іо | “MB <
display the menu. ©] [oE]
CLOG EX |
CH
2 Rotate and push the wheel | SELECT : ROTATE WHEEL
SET : PUSH WHEEL
to make your selection
(see page 6).
• To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
VCR Status & Clock Display
Push the DISPLAY button to display and remove
the overlay shown below.
Function Status Time
Rec Time REC 12:004M ММЕТ
Remaining 0:25 piers
(OTR mode only Channel &
see
page
15.)
Call
Letter
Tape
Counter Tape Speed
EE ЕА
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
On Screen Displays (OSD)
Warning and Instruction Displays
These displays will alert you to a missed operation or
provide further instructions.
If no active channels
are found for CHANNEL
MEMORY...
If a Timer Program was not
completed before exiting the
Program mode...
If you push the REC button on
the remote control or the REC
and PLAY buttons on the
Combination VCR, and a
cassette is inserted with no
record tab...
If you push the STOP
button during a Timer
Recording...
If you push the PLAY, FF, REW,
or REC button on the remote
control or if you push the REC
and PLAY buttons, the FF,
PLAY, or REW button on the
Combination VCR without a
cassette inserted...
If you attempt to set or review a
Timer Recording or set the On
Timer and the Clock is not set...
Two minutes before a Timer
Recording is about to begin...
PROGRAM IS INCOMPLETE
CHECK CASSETTE
RECORD TAB
CANCEL n
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
PLEASE SET CLOCK
BEFORE PROGRAMMING
PLEASE PREPARE
FOR TIMER REC