Panasonic Omnivision PV-M2738 - TV Timer Features

TV Timer Features
Check list before you begin.
n All connections are made {see page 5).
f~| Your Combination VCR is plugged in.
On-Timer with Alarm Feature
The Combination VCR can be set to automatically power on in one of 3
modes (TV, Playback, or FM radio). You can also combine the On-Timer
with a one minute alarm that gradually increases in volume.
1 Press ON-TIMER to display the ON
TIMER screen.
2 Press to select and ► to fix
the On-Timer time and also to
choose the On-Timer mode (TV,
PLAY, or FM radio). See the AV
selection order shown below.
• Make sure a tape is inserted if Playback
mode is selected.
• See “FM Radio Feature” on page 14 for
instructions on how to preset FM stations.
^CH02—CH03.CHI 25^
CHOI PLAY
Wm9—FM8 F M1-^
When “ON” is selected,
an alarm will gradually increase in
volume for one minute or until cancelled
by pressing any button on the remote or
Combination VCR (including VOL
When the alarm sound stops, the sound
of the mode you selected will ensue.
To Make Corrections,
use AT and to move back and correct as necessary.
4 Press ON-TIMER to set the On
Timer. This screen will appear for
about 5 seconds.
• The ON TIMER indicator lights on the front
panel.
To cancel,
press ON-TIMER to redisplay the screen in step 3. Then, press
ADD/DLT to clear the time (“6” is flashing). Now, press ON-TIMER
to end. “ON TIMER END” appears on-screen for a few seconds.
If no button on the remote or Combination VCR (including
a button used to turn off the alarm) is pressed within 60
minutes after the Combination VCR turns itself on, it will
turn itself back off.
3 Press AV to select alarm “ON” or
“OFF.”
Set the Sleep Timer
The Combination VCR can be set for auto power off.
Press SLEEP repeatedly to set the sleep
timer.
• Each press will change the time in the order shown
at right.
• If you press DISPLAY with the SLEEP TIMER set,
the remaining time will appear on-screen.
SLEEP TIMER 30
♦
SLEEP TIMER 60
♦
SLEEP TIMER 90
♦
SLEEP TIMER 00
To Cancel, press SLEEP repeatedly until “SLEEP TIMER 00” appears.
12