Panasonic Omnivision PV-M2738 - TV Operation; Picture Adjustment

in TV Operation/Picture Adjustment
|\X Check list before you begin. TV Operation
□ All connections are made (see page 5).
Q Your Combination VCR is plugged in.
COLOR Control
To adjust the intensity of the color.
TINT Control
To adjust for the most natural
fieshtones.
BRIGHTNESS Control
To adjust the brightness of the picture.
PICTURE Control
To adjust the intensity of the picture by
adjusting contrast and color level at the
same time and in the proper balance.
SHARPNESS Control
To adjust the sharpness of the picture.
1 Press POWER to turn the Combination VCR on.
2 Select a channel using CH AT or the NUMBERED keys.
3 Press VOL’^^ to adjust the volume level.
Using the 100 kev
When selecting CATV channels 100 to 125 with the NUMBERED
keys, first press the 100 key, and then enter the remaining two digits.
For example, for channel 125; Press NUMBERED keys 100-2-5.
Rapid Tune
Press R-TUNE to display the last channel you were watching.
• When selecting channels with CH at , Previous Present
the channels must be displayed for at rh^nnpi
least 4 seconds in order for the Combination
VCR to recognize them as a new selection. CH08 • ► CH10
Audio Mute
Press MUTE to instantly mute the sound.
Press again, to restore the previous sound level.
Phones
Connect an earphone (not supplied) or headphones (not supplied) to
the Phones Jack.
SELF-DEMO Mode
In Power ON condition, hold down PLAY/REPEAT on the Combination
VCR, with no tape inserted, for 5 seconds. The demo screen appears.
To cancel: Repeat the above operation. The demo screen disappears.
Picture Adjustment
3 Press MENU to display the MAIN
MENU.
b Press AT ◄► t o select “TV,” and
then press MENU to display the
SET UP TV screen.
C Press AT to select “VIDEO
ADJUST,” and then press ► to
display the VIDEO ADJUST screen.
d Press AT repeatedly to select the
desired adjust item, and then press
◄ ► to adjust. (See description at left.)
.I.
TINT I.
BRIGHT .I.
PICTURE .I
SHARPNESS .I.
NORMAL
To Reset Picture Controls to the
Factory Setting
Press AT and ► to select and set
“NORMAL.”
All controls return to their factory settings.
COLOR .).
TINT I.
BRIGHT .I.
PICTURE .H
SHARPNE SS .I.
SELECT: A t KEY
SET : ► KEY
END ;MENU KEY
G Press MENU three times to return to the normal screen.
• If no button is pressed within 5 minutes, the video adjust overlay disappears.
11
Basic
TV
Operation