Panasonic Omnivision PV-M2738 - Playback a Tape

► Playback a Tape
|\^ Check list before you begin.
O All connections are made (see page 5).
Q Your Combination VCR is plugged in.
1 Insert a cassette.
• The Combination VCR power comes on automatically.
2 Press PLAY on the remote control or Combination VCR
• Playback begins automatically if cassette has no record tab (see
page 16).
3 Press STOP on the remote control or Combination VCR
4 Press STOP/EJECT on the Combination VCR to eject
the cassette.
Caution:
Please inspect your cassette tapes
and remove any loose or peeling
labels to prevent them from
becoming jammed in your unit.
This feature continuously analyzes the signal and adjusts for optimum
picture quality.
Manual Tracking Control
Use during Playback and Slow Motion mode to reduce picture noise.
Press the 3 or 6 NUMBERED key on the remote control or CH at on the
Combination VCR until the picture clears up.
To return to Auto Tracking, press POWER off and then on again.
PanaBlack^" Picture Tube
This Combination VCR uses a PanaBlack^“ picture tube for better color
reproduction and picture contrast.
15