Panasonic Omnivision PV-M2738 - Timer Recording

Timer Recording
Your Combination VCR can be set up to do
a recording while you are away or
othenwise occupied. Up to 8 programs can
be placed in memory. You can choose to
record one time, daily, or weekly.
Check list before you begin.
n All connections are made (see page 5).
Q Your Combination VCR is plugged in.
□ The clock is set.
[~~i The tape is long enough.
Q The record tab is in place.
TIMER Indicator
PROG
1
5
6
STOP
1 Press PROG to display the SET
PROGRAM screen.
2 Press to select “TIMER
PROGRAM” and then press
► to display the program
screen.
• If a program is already in memory,
press AY repeatedly, and then ► to
select an unused program number.
3 Press AV and ► to select
and set one of the following as the DATE:
1 -31 = One time recording
DAILY = Same time MON - FRI
WEEKLY SUN-SAT = Same time once a week
SET PROGRAM
VCR Plus* PROGRAM
START STOP CH
SLP
SELECT START DATE
SELECT :a ▼ KEY
SET : ► KEY
ENO iPHOG KEY
Example
Today’s
Date
^8—9.31— 1—2.6-
7 SELECTA/T Selection Order DAILY
L WEEKLY.WEEKLY_WEEKLY J
/^ATV i#>likiv
(SAT) (MON)
(SUN)
4 Press AT and ► to select and set each of the
remaining items as follows.
Remaining Items:
• START time
• STOP time
• CH(annel) number, or LINE for outside source recording
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► or ◄ to move the cursor to the right or left,
and then make the correction.
5 Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Programs
Press AT and ► to select and set a
blank program number, and then repeat
steps 3 and 4.
6 Press PROG twice to exit this mode and return to
the normal screen.
• The PROGRAM TIMER indicator lights on the front panel.
• If you’re using a cable box. make sure that it is tuned to the
desired channel and the power is left on for timer recording.
P DT START STOP CH SPD
2-
3 -
4 -
CANCEL
SELECT
ENTER
END
ADD/Dl
1-8;*
► KEY
PROG
T KEY
Y KEY
£Y
Two minutes before the Timer Recording starts, “TIMER REC
WILL START SOON” will appear on-screen.
• If “PLEASE PREPARE FOR TIMER REC appears and/or the PROGRAM TIMER indicator flashes,
check that a cassette with record tab is loaded and the Combination VCR is in Stop mode.
• If the start times of two programs overlap, the lower numbered program will have priority.
• If the start time for a timer recording comes up during a normal recording or One Touch Recording
(page 17), the timer recording will not be performed.
• If there is a power interruption of more than one minute, the recording may not be performed or continue.
• It “INCOMPLETE" appears after all items have been set, check all entries and make necessary
corrections.
18