Panasonic Omnivision PV-M2738 - Unit and Cassette Information.25

Unit and Cassette Information
[ Maximum Record/Playback Time J
Erase Protection (Record Tab)
Only use tapes with the IVH^ mark in this unit.
Tape Speed
Setting
Type of Video Cassette
T60
T120 T160
SP
(Standard Play)
1 Hour
2 Hours
2 Hours
40 minutes
LP
(Long Play)
2 Hours 4 Hours
5 Hours
20 minutes
SLP
(Super Long Play)
3 Hours
6 Hours 8 Hours
Cassettes have a record tab to ensure that recordings
are not accidentally erased.
To prevent accidental
erasure, break off the tab
with a screwdriver. I
To record again, cover the
hole with cellophane tape.
DST. (Daylight Saving Time)
Your Combination VCR can be set to
automatically adjust the clock for Daylight Saving
Time, (page 9.)
Spring (First Sunday in April)
When set to DST:ON, the Combination VCR will
automatically set the clock ahead one hour.
Autumn (Last Sunday in October)
When set to DST:ON, the Combination VCR will
automatically set the clock back one hour.
• If your area does not observe Daylight Saving Time,
select DST: OFF.
• Keep these time changes in mind when programming
the Combination VCR for timer recordings.
(_ Head Cieaning _
Your Combination VCR will not normally require
head cleaning, however, the heads may become
clogged when playing an old or damaged tape.
Head Clog Sensor
If head cleaning becomes
necessary, the
Combination VCR will
display the screen shown
to the right during
playback of a recorded
signal. To exit this screen,
press PLAY on the remote control or
Combination VCR.
• Use “dry” type head cleaning cassette* only.
• Be sure to follow the cleaning cassette instructions
carefully. Excessive use of a cleaning cassette can
shorten head life.
• If using a head cleaning cassette does not solve the
problem, contact your nearest Factory Service Center
or authorized Senrice Center. (See page 27.)
• Cleaning cassette part No. NV-TCL30PT is
recommended.
VIDEO HEADS MAY
NEED CLEANING
PLEASE IN5ERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
[ Reset all Combination VCR Memory Functions ]
Use when moving the Combination VCR to a new
iocation, or if a mistake was made in the One Time
Setup section.
• Make sure a tape is not inserted in the Combination VCR.
1) Press POWER to turn the Combination VCR on.
2) Hold down both the PLAY and REWIND buttons
on the Combination VCR for more than 5
seconds.
• The power will shut off.
3) Turn the power back on and perform the One
Time Setup section on page 8.
Product Specifications
Display
Picture Tube:
VCR
27 inch measured diagonal 100“
deflection Picture Tube
Video Recording System:
2 rotary heads helical scanning
system
Audio T rack:
1 track
Tuner
Broadcast Channels: VHF2~13, UHF 14-69
CATV Channels:
FM Radio
Midband A through I (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CATV channel 5A (01)
Ultraband 65-94,100-125
Band range: 87.5-108.1 MHz
General
Power Source: 120V AC. 60 Hz
Power Consumption:
Approx. 157 watts (Power on)
Approx. 7 watts (Power off)
Television System: El A Standard NTSC color
Speaker: 2 pieces
Operating Temperature: 41“F-104°F (5“C-40“C)
Operating Humidity: 10%-75%
Weight: 86 lbs. (39 Kg)
Dimensions:
27-1/16" (W) X 27-15/16” (H) X
21-5/16" (D)
688 (W) X 659 (H) X 542 (D) mm
Note: Designs and specifications are subject to change
without notice.
25
Other
Information