Panasonic Omnivision PV-M2738 - VCR Plus-I- Programming.24

y CR Plus+ Programming
Easy
Ix^ Before you begin, make sure...
D The clock is set.
1 Press PROG to display the SET
PROGRAM screen.
[~| VCR Plus+ Setup is complete
(See pages 22.23).
2 Press AT to select “VCR
PIUS+ PROGRAM” and then
press ► to display the Plus
Code screen.
3 Press NUMBERED keys to enter
the PlusCode number from your
local TV listings.
To Make Corrections
Press ^4 repeatedly to delete the PlusCode
number. Then, enter the correct number.
---SET PROGRAM --
(^aai!Bizssz!a
TIMER PROGRAM
ENTER PLUSCODE NUMBER
\\y_
USING 0-9 KEYS
END :PflOG KEY
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE :•« KEY
ENTER :PR0G KEY
PROGRAM TIMER Indicator
Use normal Timer Recording
steps if:
• the PlusCode for a program is
not listed.
• you anticipate the program, such
as a sporting event, to run over
the scheduled stop time.
See page 19 to:
• cancel a timer recording in
progress.
• replace program contents.
• review or clear program contents
once set.
24
4 Press PROG to lock in your program.
5 Press the 1, 2, or 3 key to select
the program type. 1 ONCE
2 DA ILY (MON-FR I)
3 WEEKLY
TO SELECT PUSH 1. 2 OR 3
END :PR0G KEY
To Change the Recording Speed
Press SPEED for SP, LP, SLP.
To Chancel Program Contents
Press ADD/DLT,
• If you use connection type “A" on page 22, the
channel shown in this on-screen display will
always be the cable box output channel number.
[DATE START STOP CH
8 SAT 10:00P12:QQra
SLP
TO CHANGE RECORD SPEED
PUSH SPEED KEY
CANCEL:ADO/OLT KEY
ACCEPT:PROG KEY
G Press PROG to end the program.
• This screen appears for confirmation.
P OT START STOP CH SPD
1 day 9:00a 12:00a 08 SP
3-;-;-rr TT
CANCEL;ADO/DLT KEY
SELECT 1-8;A T KEY
ENTER ; ► KEY
END :PR0G KEY
7 Press PROG twice to exit this
mode and return to the normal
screen.
• The PROGRAM TIMER indicator lights on
the front panel.
• If you’re using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
• You can obtain unlisted PlusCode numbers by calling
1-900-454-7587. Call costs approximately $.95 per
minute.
• Avoid overlapping program times.
• An on-screen display will indicate if an invalid PlusCode
number has been entered.
• An on-screen display will indicate when all timer
programs are full.
LEAVE CABLE BOX POWER ON
FOR TIMER RECORDING
_ )
• This display appears if
you use a cable box.