Panasonic Omnivision PV-M2738 - Page 10

On-Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear tor a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
08
WNET
Combination VCR mode will be
displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION TWEN
PUSH CH UP KEY AGAIN
If you attempt to set or
review a Timer Recording or please set clock
set the On-Timer and the I BEFORE PROGRAMMING
Clock is not set...
(see pages 8, 9.)
1 Press MENU to
display the MAIN
MENU.
2 Press AT and
MENU to make your
selection (see page 8.)
MAIN MENU
dlMI 1^1 ^
If you press REC on the
remote control or the
CHECK CASSETTE
Combination VCR, and a RECORD TAB
\'X\ 101 int
cassette is inserted with no
record tab...
SELECT : A Y ► KEY
SET :MENU KEY
(see page 17.)
• To get the most from each feature, please read
the Operation Manual before attempting any
operation.
If you press STOP
during a Timer
Recording...
(see page 19.)
TO CANCEL TIUER REC
HOLD OOWN STOP KEY
FOR APPROX 3 SEC
VCR Status & Clock Display
Press DISPLAY to display and remove the
overlay shown below.
Function Current
Status Time
Rec Time
Remaining
(OTR mode
only see
page 17.)
N—1—/
J REC 12:00AM WNET/1
/—K- 1 —
1 REC 12:00AM
WNET/i
^ 0 : 25 0:00:00 1
( ► STEREO <- 1 SLP.
S'SAP 1
N
MONO \
/ 1
L
Channel &
Call Letter
hTape Speed
Receivable \
Broadcast Types Tape Counter
(See page 21.)
If you press PLAY, FF,
REW, or REC on the NO CASSETTE
remote control or the please insert a cassette
Combination VCR without
a cassette inserted...
(see pages 15,17.) --
If the Combination VCR is
not in Stop mode or a
cassette with record tab is
not inserted two minutes
before a Timer Recording
is about to begin...
(see pages 18, 19.)
please PREPARE
FOR TIMER REC
If head cleaning becomes
necessary while playing
back a tape...
(see page 25.)
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END: PLAY KEY
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no
broadcast signal, the TV screen will turn a solid
blue.
If you press a function
button other than
STOP/EJECT or POWER
while the Combination VCR
is in VCR Lock mode...
(See page 20.)
VCR LOCK ACTIVATED
10