18
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 11).
Camera Recording
1 Set POWER to
CAMERA.
2 Press MENU for
MENU mode.
Press
UP or DOWN to select
STAND-BY RELEASE .
3 Press M.FOCUS to select ON or OFF.
ON : From Stand-by mode, press
RECORD/PAUSE two times to
resume recording.
OFF : From Stand-by mode, set
POWER to OFF, then to
CAMERA. Press RECORD/
PAUSE to record.
4 Press MENU to exit.
Stand-by Quick Release
If left in RECORD/PAUSE mode for 5
minutes, Camcorder switches to Stand-by
mode to conserve battery. When set to
ON, Stand-by Quick Release lets you
resume recording by pressing
RECORD/
PAUSE two times. Stand-by Quick Release
is set to OFF at the factory.
a Press RECORD/PAUSE to stop
recording.
bSet POWER to OFF and leave
cassette in Camcorder.
c To resume recording, set POWER to
CAMERA.
dPress RECORD/PAUSE to resume
recording.
Note:
• Use Manual Easy Edit (left) if more than
24 hours before recording is resumed.
Manual Easy Editing
For a smooth transition between scenes if
recording is stopped, and then started
within 24 hours.
For proper continuity when taping from Stop
mode or after attaching a new Battery.
Easy Edit Stand-by
ASet POWER to VCR.
Ba Press (REWIND/SEARCH) to
rewind a few seconds of tape.
b Press
(PLAY/STILL) to review
recording.
c Press (PLAY/STILL) where
you want to continue recording.
CSet POWER to CAMERA.
DPress RECORD/PAUSE to resume
recording.
B
1,
A
,
C
,
b, c
D,
a, d
2, 3, 4
a
b
c
03.L453 Basic p17-19 02.11.28, 2:46 PM18
To Next Page
Loading...
