Panasonic Palmcorder MultiCam PV-L453 - Copying your Tapes (dubbing)

22
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Before you begin...
• Make Camcorder-VCR connections (see left).
• Turn both units on.
• Set VCR input signal to LINE.
Please see VCR owner’s manual.
• Set Camcorder POWER to VCR.
1
Insert a pre-recorded tape
into Camcorder and a blank tape with
record tab into VCR.
2
Press (PLAY/STILL) on
Camcorder, then press again at
starting point.
3
Press REC, then STILL/PAUSE on
VCR.
4
Press (PLAY/STILL) on
Camcorder and STILL/PAUSE on VCR
to start copying.
5
Press (STOP) on both units to
stop copying.
Note:
• Camcorder will only playback tapes
recorded in SP or SLP mode.
• Dubbing may reduce picture quality.
CAUTION:
Unauthorized exchanging and/or copying
of copyrighted recordings may be
copyright infringement.
Copying your Tapes (dubbing)
Connections
• Turn TV on and tune to VCR channel
(CH3 or CH4).
• Set TV/VCR Selector on VCR to VCR.
Monitor with your TV
Source
(Playing)
Camcorder
Audio/
Video Out
52, 4
04.L453 Basic p20-22(w/o P) 02.11.28, 2:46 PM22