Panasonic Palmcorder Palmsight PV-L858 - Security Mode

| Security Mode
Great for amateur surveillance applications. Before you begin...
You can select Motion, Audio, or Motions * Connect the Camcorder to a power source.
Audio Security mode. For extended Camcorder use, the AC Adaptor
is recommended as the power source.
* Insert a cassette with record tab (see page 12).
« Set the POWER switch to CAMERA.
« Aim the Camcorder at the desired area,
1 In Record/Pause mode, hold down the
SECURITY MODE button for about 2
seconds to place the Camcorder in
Motion Security stand-by mode.
Zien the SECURITY MODE button
once for Audio Security stand-by mode.
Or, press twice for MotionsAudio
Security stand-by mode. (If no cassette
tape is inserted, “gg will flash.)
MOTION
A)
Motion Security recording may start, SECURITY AUDIO
regardless of subject motion, when... MOTION*AUDIO
+ the background is plain, such as a white
wall.
» the Camcorder is pointed at something
with distinct horizonta!, vertical or oblique
stripes, such as a window shade.
e the brightness suddenly changes.
« The Camcorder will start recording
approximately 3 seconds after motion
and/or audio is detected.
« The date and time are also recorded if
displayed (see page 16).
¢ Recording will stop 30 seconds after the
motion and/or audio ceases.
Motion Security recording may not
start when...
a motion is very slow or very fast.
e moving object is very small. Press the SECURITY MODE button
* motion is in 1 corner of the viewing area. once, twice, or three times, depending
* in low light situations (MOTION SECU- on the current mode, to cancel the
RITY will flash if the light level is
inadequate.)
* the background has distinct horizontal or
vertical stripes.
* the background is plain, such as a white
Motion Security feature.
Note:
* Make sure the Camcorder is firmly secure
before activating Motion Security feature. If the
wal, Camcorder is moved, Motion Security recording
, : : will start.
Audio Security recording may start * While normal recording is being performed, the
when... Camcorder cannot be placed in Motion, Audio,
* The mic picks up wind noise (even a or MotionsAudio Security stand-by mode.
breeze). * While Camcorder is in Motion, Audio, or
Motion*Audio Security stand-by mode, Record
i i ; /Pause, Stand-by mode, Digital E.1.S., Color
Audio Security recording may not start Digital Fade, One-Touch Auto Fade, Negative/
when... Positive Transposer and Time Lapse mode can
« The sound is too abrupt. not be activated. 43