133
Problem Solving
No Machine
Operation
No machine operation To reset the machine, turn "Off" the Power Switch for a few
seconds then turn it "On" again.
--
Mode Symptom Possible Cause / Action Page
Machine Care
When lines or voids as shown in the example on the right appear on
marked Copies/Scanned Images, the scanning area may be dirty.
Wipe marks off on the Contact
Image Sensor with a dry soft cloth.
Open the ADF Cover.
Clean the Separation Roller with a
well-wrung damp cloth (with water).
Clean the Pick Up/Feed Rollers with
a well-wrung damp cloth (with water).
Clean the Pad with a soft dry cloth.
Wipe marks off on the White Sheet
with a dry soft cloth.
Close the ADF Cover.
Contact Image Sensor
ADF Cover
White Sheet
Separation Roller
Pad
Pick Up Roller
Feed Roller
A
A
To Next Page
Loading...
