Panasonic PT-D5500E - Example of Connecting with Pcs

20
Example of connecting with PCs
RGB 2 IN
VD SYNC/HD B/P
B
G/Y
R
R/P
SERIAL
REMOTE 1
REMOTE 2 IN IN OUT
LAN
DVI-D IN
RGB 1 IN
VIDEO IN
S-VIDEO IN
IN OUT
RGB 2 IN
VD SYNC/HD B/P
B
G/Y
R
R/P
SERIAL
REMOTE 1
REMOTE 2 IN IN OUT
LAN
DVI-D IN
RGB 1 IN
VIDEO IN
S-VIDEO IN
IN OUT
DVI-D Cable (Option)
(ET-SCDV03)
PC with
DVI port
PC
PC
Control PC
Note
• For the specifications of the RGB signals that can be applied from the PC, see the data sheet on
page 56.
• If your PC has the resume feature (last memory), the computer may not function properly until the
resume capability is disabled.
• When the SYNC ON GREEN signal is input, do not input sync signals to the SYNC/HD and VD
terminals. Doing so may disrupt the images since, rather than using synchronization initiated by
the GREEN signal, the sync signals of the SYNC/HD and VD terminals will be used instead. Even
if the images are not disrupted, the white balance may be lost. If this is the case, select “USER” as
the “COLOR TEMP” setting (see page 29), and adjust “W-BAL LOW”.
• The white balance may be lost when the SYNC ON RGB signal is input. If this is the case, select
“USER” as the “COLOR TEMP” setting (see page 29), and adjust “W-BAL LOW”.
Connection