49
ENGLISH
E-mail setup page
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can be
sent to one or more preset e-mail addresses (maximum two addresses). Click [Projector Control], then [E-mail
set up] to display the E-mail setup page.
Button to update settings
Minimum sending interval field
(applies only to temperature warnings)
E-mail Enable/Disable toggling SMTP server field
Set temperature selection
Memo field
(alphanumeric characters)
Sender field
Change lamp usage
time set value
ON/OFF toggling for permission to
send e-mail based on lamp usage time
Periodic warning interval setting
(e-mail is sent on the checked days of the week/times)
Destination e-mail address field
The settings for e-mail address 1 are the same.
ON/OFF toggling for permission
to send e-mail when error occurs
ON/OFF toggling for permission to
send e-mail based on air intake
sensor temperature
To Next Page
Loading...
