53
ENGLISH
Network config page
Set this to ON to enable the
DHCP client function.
Enter the IP address if DHCP
server is not used.
Enter the subnet mask if
DHCP server is not used.
Enter the gateway address if
DHCP server is not used.
Enter the name of the projector here. Enter the host name
here if it is required when the DHCP server is going to be
used, for instance.
Network status page
Click [Network set up], then [Network status] to display the Network status page.
Network software version
display
Set IP address display
Set subnet mask display
MAC address display
Network status display
To Next Page
Loading...
