Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 129
[AUTO]
Corrects the brightness of the screen by the brightness sensor.
Automatically corrects screen brightness when lamp brightness changes.
[PC]
Synchronizes nine or more projectors using a computer and dedicated software “Multi Monitoring &
Control Software”
*1
.
*1 “Multi Monitoring & Control Software” is included in the supplied CD-ROM.
f When [PC] is selected, proceed to Step 11).
7) Press as to select [LINK].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Performs corrections by the brightness sensor on a single projector without synchronizing with the
other projectors.
The period, in which the constant brightness kept by the small value of [BRIGHTNESS CONTROL
GAIN], is prolonged.
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
Synchronizes corrections in multiple projectors by the brightness sensor.
You can set up to four groups (A to D) within the same subnet by using the network function.
You can also register and synchronize up to eight projectors in one group.
9) Press as to select [CHROMA CORRECTION].
10) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Corrects only brightness.
[ON] Corrects both brightness and color.
11) Press as to select [CALIBRATION TIME].
12) Press the <ENTER> button.
f The projector is in the adjustment mode (the time is blinking).
13) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting “hour” allows setting of only the hour in increments of one hour, and selecting “minute” allows
setting of only the minute in increments of one minute between 00 and 59.
f When the time is not specied, select [OFF] between 23 and 00 of the hour, or between 59 and 00 of the
minute.
14) Press the <ENTER> button.
f [CALIBRATION TIME] is set.
f Brightness and color are measured at the specied time. Dynamic iris is xed to open during measurement.
15) Press as to select [CALIBRATION MESSAGE].
16) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Displays messages during calibration.
[OFF] Does not display messages during calibration.
17) Press as to select [APPLY].
18) Press the <ENTER> button.
f The set [MODE] and [LINK] are enabled, and LAMP RELAY screen alert is displayed when the [LAMP
RELAY] setting is [OFF]. When [CALIBRATION MESSAGE] is set to [ON], a calibration running message is
displayed which will automatically disappear 30 seconds after calibration completes.
f If the <ENTER> button is pressed with [MODE] in [BRIGHTNESS CONTROL SETUP] set to other than
[OFF], the brightness and color of the lamp at the time the button was pressed is recorded as a standard.
To Next Page
Loading...
