Chapter 4 Settings — [NETWORK] menu
170 - ENGLISH
8
7
9
8
7
7 [E-MAIL ADDRESS 1], [E-MAIL ADDRESS 2]
Enter the E-mail address to be sent. Leave [E-MAIL ADDRESS
2] blank when two E-mail addresses are not to be used.
8 Settings of the conditions to send E-mail
Select the conditions to send E-mail.
[MAIL CONTENTS]:
Select either [NORMAL] or [SIMPLE].
[ERROR]:
Send an E-mail when an error occurred in the self-diagnosis.
[LAMP1 RUNTIME]:
Send an E-mail when the remaining lamp runtime for the lamp 1
has reached the value set at the right eld.
[LAMP2 RUNTIME]:
Send an E-mail when the remaining lamp runtime for the lamp 2
has reached the value set at the right eld.
[LAMP3 RUNTIME]:
Send an E-mail when the remaining lamp runtime for the lamp 3
has reached the value set at the right eld.
[LAMP4 RUNTIME]:
Send an E-mail when the remaining lamp runtime for the lamp 4
has reached the value set at the right eld.
[INTAKE AIR TEMPERATURE]:
Send an E-mail when the intake air temperature has reached
the value set at the above eld.
[PERIODIC REPORT]:
Place a check mark on this to send an E-mail periodically.
It will be sent on the days and time with the check mark.
9 [Submit]
Update the settings.
Note
f When using the optional Replacement lamp unit (for portrait mode) (Model. No.: ET-LAD520P (1 pc), ET-LAD520PF (4 pcs)), set each item
for [LAMP1 RUNTIME] to [LAMP4 RUNTIME] to 500 hours or less.
To Next Page
Loading...
