Panasonic PT-DZ10K

As of April 2013
SFD12M023
3/17
S PEC F ILE
PT-DZ10K
3-Chip DLP
™
Projector
Keystone correction range
Installation
Terminals SDI IN
HDMI IN
DVI-D IN
RGB 1 IN
R, G, B
Y, P
B, PR (Y, CB, CR)
S-Video signal
RGB 2 IN
R, G, B
Y, P
B
, P
R
(Y, C
B
, C
R
)
VIDEO IN
Vertical ±40°, horizontal ±15°
(vertical ±22° and horizontal ±15° with the ET-D75LE5/LE50,
vertical ±28° and horizontal ±15° with the ET-D75LE6)
When using only the KEYSTONE correction of the Geometric Adjustment
function: Vertical ±40°, horizontal ±15°
Ceiling/floor, front/rear
BNC × 1,
3G-SDI signal: SMPTE ST 424 compliant
HD-SDI signal: SMPTE ST 292 compliant
SD-SDI signal: SMPTE ST 259 compliant
HDMI 19-pin × 1, Deep Color, compatible with HDCP,
VGA (640 × 480) – WUXGA*
4
(1,920 × 1,200),
dot clock: 25 MHz–162 MHz
NOTE: Compatible with non-interlaced signals only.
DVI-D 24-pin × 1, DVI 1.0 compliant, HDCP compatible,
for single link only
525i(480i)*
3
, 625i(576i)*
3
, 525p(480p), 625p(576p), 750(720)/60p,
750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p,
1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p,
1125(1080)/50p
VGA (640 × 480) – WUXGA*
4
(1,920 × 1,200),
dot clock: 25 MHz–162 MHz
NOTE: Compatible with non-interlaced signals only.
BNC ×5
R: 0.7 Vp-p, 75 ohms,
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B: 0.7 Vp-p, 75 ohms
HD, VD/SYNC: TTL, high impedance, positive/negative automatic
NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals.
Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms
Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms
D-sub HD 15-pin (female) ×1
R: 0.7 Vp-p, 75 ohms,
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B: 0.7 Vp-p, 75 ohms
HD, VD/SYNC: TTL, high impedance, positive/negative automatic
NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals.
Y: 1.0 Vp-p (including sync signal), P
B
/P
R
(C
B
/C
R
): 0.7 Vp-p, 75 ohms
BNC × 1, 1.0 Vp-p, 75 ohms
525i(480i)*
3
, 625i(576i)*
3
, 525p(480p), 625p(576p), 750(720)/60p,
750(720)50p, 1125(1080)/60i, 1125(1080)/50i, 1125(1080)/25p,
1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/30p, 1125(1080)/60p,
1125(1080)/50p
REMOTE 2 IN
LAN
D-sub 9-pin ×1 for external control (parallel)
RJ-45 ×1 for network connection, 100Base-TX/10Base-T, compliant
with PJLink™ (class 1)
SERIAL IN
SERIAL OUT
REMOTE 1 IN
REMOTE 1 OUT
D-sub 9-pin (female) ×1 for external control (RS-232C compliant)
D-sub 9-pin (male) ×1 for link control
M3 jack ×1 for wired remote control
M3 jack ×1 for link control
(RS-232C compliant)
Power cord length
Cabinet materials
3.0 m (9
10 in)
Molded plastic
Dimensions (W ×H × D):
Weight*
6
Operation noise*
2
530 × 200*
5
× 548.5 mm
(20-7/8 × 7-7/8*
5
× 21-19/32 inches) (without lens)
24 kg (52.9 lbs) (without lens)
43 dB (normal mode), 37 dB (eco mode)
Operating temperature
Operating humidity
0°– 45°C (32°–113°F)*
7
10%–80% (no condensation)