-26-
Mechanical Disassembly
4. Shutter and sensor C board removal
1.
Remove 3 screws-A (M3x10)
and 4 screw-B (T3x10)
to take the main board
shield bottom.
2. Loosen 1 hex screw-C and pull the shutter assy upward.
3. Remove 1 screw-D (T3x8) to take the sensor C board off.
4. Remove 1 screw-E (T3x8) to take the lamp cover switch off.
5. Remove 2 screws-F (T3x14) to take the wind sensor (S901) off.
6. Remove 1 screws-G (T3x10) to take the connect shield,
and remove 2 screw-H (T3x10) to pull the net shield
upward.
5. Lamp, lamp cover and ID connect board removal
1. Loosen 3 screws-A and pull the lamp assy upward.
2. Remove 4 screws-B (T3x8) to take the lamp house holder upward off.
3. Remove 2 screws-C (T3x8) to take the ID connect board.
4. Remove 1 screw-D (T3x10) to remove the ballast socket.
C
B
B
A
A
D
E
F
H
G
H
Shutter assy
Lamp cover switch
Sensor C board
Wind sensor (S901)
Net shield
A
A
B
B B
B
C
ID connect
board
Lamp assy
C
A
Ballast
socket
D
Main board
shield bottom
Connect shield
A
B
B
To Next Page
Loading...
