Panasonic PT-EW630U

-51-
Electrical Adjustments
3. Auto calibration adjustment [PC]
(For PT-EW630)
Input mode Input 1 (RGB(PC analog))
Input signal XGA computer signal
Signal pattern 16-step gray scale
1. Enter the service mode.
2. Select Group "200", No. "70" and set data value to
"0". Select Group "200", No. "72" and set data value
to "0".
3. Select Group "260", No. "0" and set data value "0"
to "1".
The projector begins auto-calibration for MAIN and
then "OK" will appear on the screen.
4. Select Group "200", No. "70" and set data value
to "1".
5. Select Group "260", No. "0" and set data value "0"
to "1".
The projector begins auto-calibration for SUB and
then "OK" will appear on the screen.
6. Select Group "200", No. "70" and set data value
to "0". Select Group "200", No. "72" and set data
value to "1".
4. Auto calibration adjustment[Component]
(For PT-EW630)
Input mode Input 2 (Component)
Input signal 100% color bar signal (480i)
100% color bar signal (480p)
100% color bar signal (720p)
100% color bar signal (1080i)
1. Enter the service mode.
2. At first, input the 100% color bar signal (480i).
3. Select Group "200", No. "72" and set data value
to "0". Select Group "200", No. "71" and set data
value to "1".
4. Select Group "260", No. "0" and set data value "0" to
"1".
The projector begins auto-calibration and then "OK"
will appear on the screen.
5. Select Group "200", No. "71" and set data value
to "0".
6. Select Group "260", No. "0" and set data value "0"
to "1".
The projector begins auto-calibration and then "OK"
will appear on the screen.
7. Change another input signal and take steps 3 - 6 again.
8. Select Group "200", No. "71" and set data value to
"1". Select Group "200", No. "72" and set data value
to "1".
5. Auto calibration adjustment [Video]
(For PT-EW630)
Input mode Input 3 (Video)
Input signal 100% color bar composite video signal
1. Enter the service mode.
2. To start the auto-calibration for composite-video
adjustment, select Group "260", No. "0", and then
change data value "0" to "1".
After the auto-calibration completed, "OK" will appear
on the screen.