Panasonic PT-JW130FBE - [HIGH ALTITUDE MODE]; [ECO MANAGEMENT]

Chapter 4 Settings — [SETUP] menu
ENGLISH - 71
[IMAGE CONTENT]
The signage playback (schedule) restarts and the input switches to the signage at the start time
of a image content (still images/movies/external input contents/playlists in SD card) that is set as
schedule.
4) Press qw to select [DISABLE] or [ENABLE].
[DISABLE]
Disables the restart option.
[ENABLE]
Enables the restart option.
Note
f When [PLAY MODE] is set to [SLIDESHOW], [POWER] and [IMAGE CONTENT] in the restart option cannot be selected.
f Signage playback will not be restarted if an SD card is not inserted or no schedule is registered in the SD card.
f Signage playback can be restarted also by pressing the <SIGNAGE> button on the remote control. Pressing the <SIGNAGE> button
while signage playback is stopped switches the input to signage and restarts or starts signage playback. In addition, pressing each of the
<HDMI>, <MEMORY VIEWER>, <Miracast>, <Panasonic APP>, or <LIGHTING/PROJECTOR> button while in signage playback stops
signage playback and switches the input or projection mode to a corresponding one.
[HIGH ALTITUDE MODE]
Set this item to other than [OFF] when using the projector at high altitudes between 1 000 m (3 281') and 2 700 m
(8 858') above sea level.
1) Press as to select [HIGH ALTITUDE MODE].
2) Press the <ENTER> button.
f The [HIGH ALTITUDE MODE] screen is displayed.
3) Press as to select an item, and press the <ENTER> button.
[OFF]
Select this item when using the projector at a location lower than 1 000 m (3 281') above sea level.
[HIGH1]
Select this item when using the projector at a location between 1 000 m (3 281') and 2 000 m (6 562')
above sea level.
[HIGH2]
Select this item when using the projector at a location between 2 000 m (6 562') and 2 700 m (8 858')
above sea level.
4) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The speed of the internal cooling fan increases and the operation sound becomes louder when [HIGH1] or [HIGH2] is set.
[ECO MANAGEMENT]
This function optimizes power according to the operating status to reduce power consumption.
Setting [LIGHT POWER]
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [LIGHT POWER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Select this item when high luminance is required.
[ECO]
Select this item when high luminance is not required.
Note
f When [ECO] is set, the power consumption can be saved and operation sound can be reduced compared to when [NORMAL] is set.
f When [ECO] is set, the images may appear different from that when [NORMAL] is set.