Panasonic PT-JW130FBE

Chapter 4 Settings — [SETUP] menu
ENGLISH - 73
[LAST MEMORY]
Starts up the projector in a status before turning off the power supply of the interior wiring or
disconnecting the plug of the power cord from the outlet.
[STANDBY]
Starts up the projector in standby.
[ON]
Starts projecting immediately.
[STARTUP INPUT SELECT]
Set the projection mode and input when the projector is turned on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST USED]
Keeps the projection mode and input that has been selected the last time.
[HDMI]
Sets the input to HDMI.
[Miracast]
Sets the input to Miracast.
[Panasonic APPLICATION]
Sets the input to Panasonic APPLICATION.
[MEMORY VIEWER]
Sets the input to Memory Viewer.
[SIGNAGE]
Sets the input to signage.
[LIGHTING]
Starts projecting in the lighting mode.
Note
f If [POWER] of the restart option is enabled in “Setting the restart option” (x page 70) which explains the [SETUP] menu → [SIGNAGE],
the input switches to signage regardless of the [STARTUP INPUT SELECT] setting, as the signage playback (schedule) restarts at the same
time when the power is turned on.
[AUDIO SETTING]
Set detailed audio functions.
Adjusting the volume
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume.
0 - 63
Press q.
Decreases the volume.
Adjusting the right/left audio balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume on the right.
L16 - R16
Press q.
Increases the volume on the left.
Note
f The projector has no built-in speakers. Audio is output from the external audio system connected to the <AUDIO OUT> terminal.