Panasonic PT-LB10NTU - Removal of Analysis Block and Lens; Removal of LCD Block; Replacement of LCD Panel

Note:
· When installing the lamp unit (or a new one) in the
main unit, place it in a specified position and press
the connector side and the opposite side of the lamp
unit (arrow positions shown in the figure below), and
confirm the lamp unit isinserted securely.
Then, tighten the 2 screws fixing the lamp unit, and
attach the lamp unit cover.
7.11. Removal of Analysis Block
and Lens
1. Remove the lamp unit according to the section 7.10.
"Removal of Lamp Unit".
2. Remove the A-P.C.Board block according to the steps 1
through 6 in the section 7.3. "Removal of A-P.C.Board".
3. Unscrew the 3 screws and remove the analysis block, LCD
block and lens.
4. Unscrew the 4 screws A and remove the lens.
5. Unscrew the 2 screws B and remove the LCD block (the
analysis block remains).
7.12. Removal of LCD Block
1. Remove the A-P.C.Board block according to the steps 1
through 6 in the section 7.3. "Removal of A-P.C.Board".
2. Unscrew the 2 screws and remove the LCD block.
Note:
· Be careful not to touch the surface of prism and LCD
panel.
7.13. Replacement of LCD Panel
· The procedure is described as an example of LCD panel
(B).
18
PT-LB10NTU / PT-LB10NTE / PT-LB10U / PT-LB10E / PT-LB10VU / PT-LB10VE / PT-LB10SU / PT-LB10SE