8.5.3.2. G Reflector Adjustment
1. Turn on the power and display 100 % white pattern on the
screen.
2. Loosen the 2 screws fixing the mirror adjusting lever A just
until the lever can be shifted.
3. Adjust the mirror adjusting lever A position to minimize color
unevenness on the screen by shifting the lever in arrow
directions.
4. Tighten the 2 screws.
8.5.3.3. R Reflector Adjustment
1. Turn on the power and display 100 % white pattern on the
screen.
2. Loosen the 2 screws fixing the mirror adjusting lever B just
until the lever can be shifted.
3. Adjust the mirror adjusting lever B position to minimize color
unevenness on the screen by shifting the lever in arrow
directions.
4. Tighten the 2 screws.
8.5.3.4. B Reflector Adjustment
1. Turn on the power and display 100 % white pattern on the
screen.
2. Loosen the 2 screws fixing the mirror adjusting lever C just
until the lever can be shifted.
3. Adjust the mirror adjusting lever C position to minimize color
unevenness on the screen by shifting the lever in arrow
directions.
4. Tighten the 2 screws.
8.6. Software for Adjustment
8.6.1. Outline
·
This projector needs computer-aided adjustments.
·
After the software adjustments, this projector must be
turned off and on again to memorize the settings.
·
Connect the cable between the projector and a PC as
shown below.
·
Updating the software will change the version number.
8.6.2. Operating Procedure
1. Run software program by the keyboard entry.
Note:
·
Use the software program as below.
Adjustment Tool [LB10]
2. The first menu is Port selection menu.
3. Adjust the projector by selecting the necessary item from
the menu in each stage.
8.6.3. Port Selection Menu
Select the applying item with the list box and click "Data" or
"Adjustment".
25
PT-LB10NTU / PT-LB10NTE / PT-LB10U / PT-LB10E / PT-LB10VU / PT-LB10VE / PT-LB10SU / PT-LB10SE
To Next Page
Loading...
