Panasonic PT-LB2U

Preparation
10  ENGLISH
Start-up display
The LANGUAGE and INITIAL SETTING menu will be displayed when the projector is turned on for the rst time or
after it has been initialized. (

page 39)
Navigate the DISPLAY OPTION menu to set the menus in accordance to its application and environment settings.
NOTE:
When the projector is turned on for the rst time, you may be required to adjust the “zoom ring” and “focus ring” • (

page 11)
on the top of the projector body to make the menu screen clearer.
For details, see POSITION THE IMAGE. (

page 22)
1
To select the desired language.
PLEASE SELECT LANGUAGE.
SELECT
ENTER
INITIAL SETTING
2
ENTER
To proceed to INITIAL SETTING
menu.
1
To select the desired menu.

INSTALLATION

HIGH ALTITUDE MODE
2
To change the settings in the
menu.
RETURN
SELECT
ENTER
INSTALLATION
INITIAL SETTING
FRONT/DESK
HIGH ALTITUDE MODE
SWITCH TO HIGH ALTITUDE MODE “ON” IF OVER 1400m(4593Ft).
OFF
INSTALLATION (

page 15, 37)
FRONT/
DESK
Put it on a desk or oor and project
from the front
FRONT/
CEILING
Mount it on the ceiling with a ceiling
mount bracket (sold separately) and
project from the front
REAR/
DESK
Put it on a desk or oor and project
from the rear (a translucent screen is
required)
REAR/
CEILING
Mount it on the ceiling with a ceiling
mount bracket (sold separately) and
project from the rear (a translucent
screen is required)
HIGH ALTITUDE MODE (

page 7, 37)
OFF
Use in normal environment
(below 1 400 m (4 593 ft) above sea
level)
ON Use at high altitude
(at 1 400 - 2 700 m (4 593 - 8 858 ft)
above sea level)
3
ENTER
NOTE:
To return to • LANGUAGE menu, press [RETURN] in
INITIAL SETTING menu.
LANGUAGE
INITIAL SETTING
Preparation