Panasonic PT-LB356 - Page 40

40 - ENGLISH
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [LANGUAGE] menu.
1) Press asqw to select the display language.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
If necessary, change the setting of each item.
PT-LW376, PT-LW336
PT-LB426, PT-LB386,
PT-LB356
PT-LB306
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
protocol commands.
STANDBY MODE
SCREEN POSITION
AUTO
NORMAL
16:10
ENTER
SELECT
RETURN
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
protocol commands.
STANDBY MODE
SCREEN POSITION
AUTO
NORMAL
4:3
ENTER
SELECT
RETURN
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
If STANDBY MODE is set to ECO,
you cannot use some RS-232C protocol commands
when the projector is standing by.
STANDBY MODE
STANDBY MODE
AUTO
NORMAL
4:3
ENTER
SELECT
RETURN
NORMAL
1) Press as to select an item.
Item Description Page
[PROJECTION METHOD]
Set [PROJECTION METHOD] depending on the installation mode.
After completing the initial setting, you can change the setting from the [PROJEC-
TOR SETUP] menu → [PROJECTION METHOD].
29, 75
[SCREEN FORMAT]
*1
Set the screen format (aspect ratio) and display position of the image.
After completing the initial setting, you can change the settings of each item from the
[DISPLAY OPTION] menu → [SCREEN SETTING].
70
[SCREEN POSITION]
*1
Set the display position of the image.
After completing the initial setting, you can change the settings of each item from the
[DISPLAY OPTION] menu → [SCREEN SETTING].
70
[STANDBY MODE]
Set the operation mode during standby. The default setting is [NORMAL], which al-
lows you to use the network function during standby. If you want to reduce the power
consumption during standby, it can be set to [ECO]. If you want to keep the power
consumption low during standby, and to perform operation of power-on via wired
LAN with the Wake on LAN function, set to [NETWORK]
*1
. After the initial setting is
completed, you can change the setting from the [PROJECTOR SETUP] menu →
[ECO MANAGEMENT] → [STANDBY MODE].
77
*1 Not available for PT-LB306.
2) Press qw to switch the setting.
f When all settings are completed, proceed to Step 3).
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Chapter 3 Basic Operations - Powering on/o󰀨