82 - ENGLISH
[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (x page 52) for the operation of the menu screen.
f When the projector is used for the rst time
Initial password: 1111
Attention
f When you select the [SECURITY] menu and press the <ENTER> button, entering a password is required. Enter the preset password and
then continue operations of the [SECURITY] menu.
f When the password has been changed previously, enter the changed password, and press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
[PASSWORD]
The [PASSWORD] screen is displayed when the power is turned on, [INITIALIZE ALL] is executed or [INITIALIZE]
in the [NETWORK] menu is executed. When the entered password is incorrect, the operation will be restricted to
the power standby <v/b> button on the control panel or on the remote control.
1) Press as to select [PASSWORD].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables the security password entry.
[ON]
Enables the security password entry.
Note
f The [PASSWORD] setting is set to [OFF] by the factory default.
f The security password input when turning on the power is not enabled until turning o the power supply and plugging the power plug into
the outlet after setting it to [ON]. If the entered password is incorrect when the power is turned on, the operation will be restricted to the
power <v/b> button.
[PASSWORD CHANGE]
Change the security password.
1) Press as to select [PASSWORD CHANGE].
2) Press the <ENTER> button.
f The [NEW] screen is displayed.
3) Press qw and <ENTER> button to input the new password.
f A password of 4 digits must be input.
4) Press as to select [OK], and press the <ENTER> button.
f The [CONFIRM] screen is displayed.
5) Re-enter the password for the confirmation.
6) Press as to select [OK], and press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f Change the password periodically and make it hard to guess.
[TEXT DISPLAY]
Overlap the security message (text) over the projecting image.
1) Press as to select [TEXT DISPLAY].
2) Press qw to switch the item.
Chapter 4 Settings - [SECURITY] menu
To Next Page
Loading...
