Panasonic PT-LW312

ENGLISH - 35
Powering on/off
Connecting the power cord
Make sure that the supplied power cord is securely xed to the projector body to prevent it from being removed easily.
For details of power cord handling, refer to “Read this rst!” (x page 2).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction.
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Conrm the status of the power indicator
<ON(G)/STANDBY(R)> before operating the projector.
Indicator status Status
No illumination The projector is turned off. (The power cord is unplugged.)
Red
Lighting The projector is turned off. (In standby mode)
Blinking
The projector is in warming up after turning on the power.
The projector is in projected state after a while.
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
Green
Lighting Projecting.
Blinking The projector is in ready mode with Power management function.
Orange
Lighting The abnormal inside is detected. (Warning)
Blinking The temperature inside the projector is abnormally high. (Warning)
x
Power indicator <ON(G)/STANDBY(R)>
Chapter 3 Basic Operations - Powering on/off