26
Other operations for connection (cont.)
Click [Search].
When <Other search> window – [Searching] is displayed, the search starts.
3
Click [Connect].
When the connection with the projector is established, the launcher is
displayed.
(“Description of the launcher” → See page 28)
5
Check the search results.
When the projector of the applicable ID is found, the [Projector Name] and [ID]
appear.
4
If a projector of the applicable ID is not found, [No Projector detected.] appear.
The launcher is projected by the projector.
Automatic connection by “One-click connection”
An automatic connection can be established using the created profile.
This function is called “One-click connection.” (Create a profile → See page 27)
Perform step A or B.
A
Double-click the profile.
(This function cannot be used when using without installation.）
B
Drag and drop the profile onto the destination of installation or [ ] in the Dock.
The computer connect to the projector that was connected when the profile was created.
To Next Page
Loading...
