60
Using WebBrowser (cont.)
Time settings
Click [Detailed set up]→[Adjust clock] in the menu.
Time zone : Select the time zone and click [Set
time zone].
Time : Enter the current date and time in
[Date] and [Time], and then click [Set
date and time].
Email settings
You can specify two email recipients.
Click [Detailed set up]→[E-mail set up] in the menu.
• [MAIL SERVER]
ENABLE : Enable or disable email transmission.
SMTP SERVER NAME : Enter the SMTP server name.
• [MAIL OPTION]
MAIL FROM : Enter the sender’s email address.
MEMO : Enter a description of the sender.
• [TEMPERATURE WARNING SET UP]
MINIMUM TIME : Enter the interval for sending email.
INPUT AIR TEMPERATURE
: Select the temperature of the intake
sensor at which to send a warning
message.
• [E-MAIL ADDRESS]
E-MAIL ADDRESS : Enter the email addresses of the
recipients.
MAIL CONTENTS : Change the type of message as
desired.
When sending messages to mobile
phones, select “SIMPLE.”
ERROR : Select ON to send email when errors occur.
LAMP RUNTIME : Select ON to send email when “at REMAIN” is reached.
FILTER REMAINING TIME : Select ON to send email when “at REMAIN” is reached.
INPUT AIR TEMPERATURE
: Select ON to send email when the temperature set in [TEMPERATURE WARNING SET UP] is
exceeded.
PERIODIC REPORT : Send a message with the projector status at the selected date and time.
When [submit] is clicked, the settings are applied.
Connection test
You can confirm if a network connection is established with Mail
server, POP server, DNS server or the like.
Click [Detailed setup] → [Ping test] from the network main menu.
Destination IP address: Enter the IP address of the server you want
to test, and then click [Submit].
If succeeded in connection, the following display appears.
If failed in connection, the following display appears.
To Next Page
Loading...
