Panasonic PT-LW80NT - Verifying Settings; Returning to the Initial Settings

54
Network/Security setting of the projector (cont.)
INITIALIZE
RETURN
ENTER
SELECT
INITIALIZE
OK CANCEL
Your current settings appear.
Select [STATUS] at the network menu and press the [ENTER] button.
Verifying settings
You can reset the network setting to the factory default of the projector.
Select [INITIALIZE] at the network menu and press the [ENTER] button.
1
Select [OK] with the [ ] buttons and press the [ENTER]
button.
2
Returning to the initial settings
The entry of the password is prompted if [Password setting] is turned [ON] in the [ Security] menu.
The status of the following will appear.
WIRED LAN WIRELESS LAN
DHCP “ON” - “OFF” ANTENNA LEVEL (The strength of the connection will appear.)
IP ADDRESS (See page 47) NETWORK “S-MAP”, “1” - “4”, “USER1” - “USER3”
SUBNETMASK (See page 47) MODE “AD-HOC” - “INFRASTRUCTURE”
DEFAULT GATEWAY (See page 47) CHANNEL Refer to page 5 for usable channels.
MAC ADDRESS SSID (See page 49)
AUTHENTICATION “OPEN” - “SHARED” - “WPA-PSK” - “WPA2-PSK”
DEFAULT KEY “-” - “1” - “4”
ENCRYPTION “NONE” - “WEP” - “TKIP” - “AES”
DHCP “ON” - “OFF”
IP ADDRESS (See page 48, 50)
SUBNETMASK (See page 48, 50)
DEFAULT GATEWAY (See page 48, 50)
MAC ADDRESS
RETURN
ENTER
SELECT
LANGUAGE
PROJECTOR SETUP
SECURITY
POSITION
DISPLAY OPTION
WIRED LAN
NAME CHANGE
COMPUTER SEARCH
MULTI-LIVE
STATUS
INITIALIZE
PICTURE
NETWORK
S-MAP
WIRELESS LAN
PASSWORD
OFF
PASSWORD CHANGE
OFF
NETWORK STANDBY
NETWORK CONTROL
ON
LIVE MODE CUT IN
OFF
RETURN
ENTER
SELECT
LANGUAGE
PROJECTOR SETUP
SECURITY
POSITION
DISPLAY OPTION
WIRED LAN
NAME CHANGE
COMPUTER SEARCH
MULTI-LIVE
STATUS
INITIALIZE
PICTURE
NETWORK
S-MAP
WIRELESS LAN
PASSWORD
OFF
PASSWORD CHANGE
OFF
NETWORK STANDBY
NETWORK CONTROL
ON
LIVE MODE CUT IN
OFF