About Your Projector
ENGLISH -
19
Preparation
Connecting terminals
(
1) <HDMI IN>
This is a terminal to connect to HDMI signal.
(2) <MONITOR OUT>
This is a terminal to output the RGB signal or
YC
B
C
R
/YP
B
P
R
signal via <COMPUTER 1 IN> or
<COMPUTER 2 IN> terminal.
(3) <COMPUTER 1 IN>
This is a terminal to input the RGB signal or
YC
B
C
R
/YP
B
P
R
signal.
(4) <VIDEO IN>
This is a terminal to input the video signal.
(5) <AUDIO 2 IN>
This is a terminal to input the audio signal from
the video equipment connected to the <VIDEO
IN> terminal.
(6) <AUDIO 1 IN>
This is a terminal to input the audio signal from
the computer connected to the <COMPUTER 1
IN> or <COMPUTER 2 IN> terminal.
(7) <LAN>
This is a terminal to connect to the network.
(8)
<SERIAL IN>
This is a RS-232C compatible terminal to
externally control the projector by connecting a
computer.
(9) <COMPUTER 2 IN>
This is a terminal to input the RGB signal or
YC
B
C
R
/YP
B
P
R
signal.
(10) <VARIABLE AUDIO OUT>
This is a terminal to output the audio signal input
to the projector.
Attention
When a LAN cable is directly connected to the projector,
z
the network connection must be made indoors.
Note
When the <HDMI IN> terminal is connected to a
z
computer via a HDMI-DVI conversion cable, it can only
input video signal and the analog audio signal can not be
input.
To Next Page
Loading...
