Panasonic PT-LX321

Setting up
22
- ENGLISH
Getting Started
Screen size and throw distance
Place the projector referring to the diagram on the right and the gures of throwing distance. You can adjust the
display size.
Attention
Before installing, please read “Precautions for Use”. (
z
Æ
pages 12 to 15)
Do not use the projector and the high-powered laser equipment in the same room. Hitting of a laser beam on to the lens
z
can damage the DLP chips.
Projection distance for PT-LW321U and PT-LW271U
J
All measurements below are approximate and may differ slightly from the actual measurements. (Unit: m)
Projection size For 4:3 aspect ratio For 16:9 aspect ratio For 16:10 aspect ratio
Screen
diagonal
(SD)
Minimum
distance
(LW)
Maximum
distance
(LT)
Height
position
(H)
Minimum
distance
(LW)
Maximum
distance
(LT)
Height
position
(H)
Minimum
distance
(LW)
Maximum
distance
(LT)
Height
position
(H)
0.76 (30") 1.2 1.3 0.06 1.0 1.1 0.07 1.0 1.1 0.05
1.02 (40") 1.5 1.7 0.08 1.4 1.5 0.10 1.3 1.5 0.07
1.27 (50") 1.9 2.1 0.09 1.7 1.9 0.12 1.7 1.8 0.08
1.52 (60") 2.3 2.5 0.11 2.1 2.3 0.14 2.0 2.2 0.10
1.78 (70") 2.7 2.9 0.13 2.4 2.6 0.17 2.3 2.6 0.12
2.03 (80") 3.0 3.3 0.15 2.7 3.0 0.19 2.7 2.9 0.13
2.29 (90") 3.4 3.7 0.17 3.1 3.4 0.22 3.0 3.3 0.15
2.54 (100") 3.8 4.2 0.19 3.4 3.8 0.24 3.3 3.7 0.17
3.05 (120") 4.5 5.0 0.23 4.1 4.5 0.29 4.0 4.4 0.20
3.81 (150") 5.7 6.2 0.28 5.1 5.7 0.36 5.0 5.5 0.25
5.08 (200") 7.6 8.3 0.38 6.9 7.5 0.48 6.7 7.3 0.33
6.35 (250") 9.5 10.4 0.47 8.6 9.4 0.60 8.3 9.2 0.42
7.62 (300") 11.3 12.4 0.57 10.3 11.3 0.72 10.0 11.0 0.50
Projected image
SH
SD
SW
Screen
L (LW/LT)
H
SH
L (LW/LT)
Screen
SW
L (LW/LT) *
1
Projection distance (m)
SH Height of the projection area (m)
SW Width of the projection area (m)
H
Distance from the center of lens to
the image lower end (m)
SD
Diagonal length of the projection
area (m)
*1: LW: Minimum distance, LT: Maximum distance